Parts

4D leading edge connector  - sold individually per piece Holding your kites spreaders firmly in place along the leading edges under all sorts of wind conditions is no easy job, but these specially molded parts are up to the task. Be sure to check...

Nexus leading edge connector "ferrule"  - sold individually per piece They slide onto your upper and lower spars to connect the leading edge spars together. Not too exciting you say? Just try and fly without them and see how much fun you have!

Nexus Standoff Stand offs are all about giving the sail its shape. They’re sold individually.

Nexus Spine -T connector and inner bridle.

Nexus Wingtip Nocks These are the pieces that go on the end of the leading edge rods and have a groove in them, used to tension the sail. Nocks sold individually.

Nexus Spreader   While it is the one part that seems to break least often, this spar does tend to get "misplaced" from time to time. Whatever happened to the original we've got you covered. Fits the Nexus 2.0 as well as the older, 'standard'...

Zenith 5 Leading edge spar. This is the spar that runs down the outside of the kite from the nose to the wingtips. This will fit the Zenith 5 and the Stowaway Delta.

Nexus Standoff Retainer Fittings - sold individually per piece These fittings retain the stand offs. They slide onto your lower spreader and have a hole for the standoff to go into. Not too exciting you say? Just try and fly without them and see how...

STOPPER CLIP 8mm  

STOPPER CLIP 6mm  

Jazz Upper Spreader - sold individually per piece Connects from the upper leading edge of the kite. With tricks like The Flapjack, Lazy Susan and Jacob’s Ladder, it’s no surprise that flyers crack up these spars the most. Even if you broke...

Leading Edge Fitting - sold individually per piece These molded Fittings are where the rubber meets the carbon. Keep your leading edges connected to your spreader spars.